Wall Frame Fixings

Also referred to as ‘Stud Anchor’ due to being used for stud to top plate fixing.

Replace the strength lost in 90 x 45mm framing studs as a result of holes being drilled through timber framing for plumbing or vacuum systems ducting.

Used to fasten the top of internal non load bearing walls to trusses.

Ideally suited for right angle wall connections with a unique clear centre section to allow easy overlapping.

This product is used to tie brick veneer to timber framework.

Provides the ability to save timber studs, primarily at right angle wall junction points where traditional timber stud / block / stud junctions appear.

Designed to secure studs to top plate, this pre-bent strap product can be applied to one face only, saving time over alternative fixing methods.

Tested to re-strengthen timber top plates where holes have been drilled for the installation of internal vacuum system ducting.

This product is used to tie brick veneer to timber framework.